Shipping
What container loading supervision actually checks
A pre-shipment inspection tells you what was in the cartons on the day it was checked. Loading supervision tells you what actually went into the container, in what condition, on the day it was sealed. The gap between those two facts is where shipments quietly go wrong.
Why it exists as a separate job
The inspection happened last week; the factory has been packing since. Between a passed report and a sealed container sit several days in which cartons can be topped up with units that never saw the QC table, spare parts can "go missing", and cartons from another order can be loaded to fill space. Loading supervision exists because the last day of packing is the only day that counts.
The checklist, in order
| Stage | Checked |
|---|---|
| Container arrives | Container condition — rust holes, broken door seals, odors from previous cargo (spices and chemicals ruin food-grade goods), floor condition, valid inspection sticker |
| Before loading | Carton count against the packing list; approved shipping marks; carton condition; pallet-versus-loose-load plan |
| During loading | Random opening of inner cartons against the packing list; correct product and quantity per carton; stacking method so cartons are not crushed; dunnage and dry bags where needed |
| Closing | Final count, container number and seal number photographed and recorded, door closed and sealed in view, loading time and weather logged |
The failures it actually catches
- Short-ship. Packing list says 8,000; the container holds 7,550. Found in 30 minutes of counting, invisible from anywhere else.
- The swap. 500 "filler" cartons from a different order taking up your container space — making you pay to ship their goods and risking a customs mismatch.
- Wet or damaged cartons may be loaded without comment, fail in transit, and lead to a moisture claim being rejected at destination if no one can prove when the water got in.
- Bad container. A holed or smelly container can be rejected in five minutes — five minutes that can save the entire shipment, and it happens more often than you would expect.
- Mixed production runs. Cartons from a second, cheaper run slipped in after inspection. Random inner-carton openings catch it.
Photos at every stage: empty container interior with the doors open, each pallet row as it goes in, the seal number close-up, and the sealed doors. Plus the tally count, the seal number on paper, and any deviation noted during loading — not discovered after arrival. If a loading report has no photo of the seal, supervision did not run to the end.
How it fits the sequence
The sequence is inspection before loading, supervision during loading, then shipment follow-up: check the B/L draft against the packing list, confirm that the documents match the contract, and track the container to port. Each stage covers the gap the previous one cannot see. Buyers who run all three rarely write angry emails; buyers who run none fund everyone else’s lessons.
A full guide to the inspection stage is here: what an AQL pre-shipment inspection covers.
Book on-site loading supervision
Loading supervision across Guangdong for a fixed daily rate, documented with photos from the empty container through to recording the seal number.